3D Glock Animation - How to disassemble and reassemble the G20

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
the g20 is one of the many highly sophisticated models in Galax line of firearms in this video you will learn how to disassemble and reassemble the g20 first and foremost always treat firearms as if they were loaded so keep the muzzle pointed in a safe direction here we will handle the five major components of the g20 and not to symbol the entire weapon first remove the magazine by pressing down the magazine catch found on the left side of the receiver near where the thumb rests this will release the magazine allowing you to slide it out next make sure there's no ammunition inside the barrel to do this keep the gun pointed in a safe direction pull the slide backwards and hold then look inside the barrel once you have verified there's no ammunition inside pull the trigger dry firing typically is bad for a gun but it won't be a problem for Glocks because of their quality manufacturing in fact pulling the trigger at this point is necessary for the following step and the third step you will remove the slide verify that the trigger is still in the pulled back position if not this step will be impossible this is probably the hardest part into system like a Glock there are two things you must do simultaneously to remove the slide first grip the gun in this fashion all four fingers on top of the slide and the thumb wrapped around the grip note the two slide locks on either side of the gun with your free hand place a thumb on one side and a finger on the other this next step is crucial on the grip press down on the slide with your fingers and pull backwards allow to slide back about a half-inch but no farther if you pull too far the slide will reset the trigger once you slide it back a half-inch apply forceful inward and downward pressure with the other hand on the slide locks then guide the slide forward if performed correctly the slide will be released and move freely if it doesn't work repeat this step and remember to apply plenty of pressure on the slide locks once the slide is free remove it from the receiver and set the receiver aside the next step is to remove the recoil rod which is found on the bottom of the slide with a finger and thumb grip both ends and squeeze the inner end of the recall ride towards the outer then pull the inner end away from the barrel and set it aside the last step is to remove the barrel first pull the barrel outwards away from the slide until it stops then push it farther forward into the opening arrest is in and finally outwards again to free it the Glock is now disassembled to reassemble the Glock insert the barrel back into the larger opening on the slides tip push the back end inner words then pull it backwards into place next insert the recoil rod into the loop on the slides tip making sure the end without the hole faces in the direction of fire note the little steps on the bottom of the barrel the back end of the recoil rod must rest in the cutout scoop to make this happen you must squeeze hard both ends of the recoil rod until aligns up with the scoop then push towards the barrel to snap it in place on the receiver note the teeth sticking out on the top line those up with the inserts on the rear of the slide pull the slide back as far as it will go to snap the inner components in place insert the magazine making sure the bullet count indicators are facing the rear note that there is only one way the magazine will fit in lastly pull the slide back to lock it in place you have reassembled the Glock
Info
Channel: Jay Xiong ART
Views: 3,733,574
Rating: 4.905067 out of 5
Keywords: Glock, 20, weapons, arms, modern, warfare, m-16, guns, firearms, bullets, 3d, animation, 3ds, max, maya, 17, 19, austria
Id: 4vgXPK74nlI
Channel Id: undefined
Length: 3min 53sec (233 seconds)
Published: Thu Dec 17 2009
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.