Drip Edge Flashing - Inside Corners

corners we're gonna do it a little different we're gonna go one foot same thing transpose it right there and it's an inch and a half so we're gonna go over an inch and a half so this is the piece we that's the leftover 12 inches so same thing i'm gonna transpose this onto here sharpies going out brand new all right got straight down like that it's an inch and a half so remember we're gonna go an inch and a half over just like that i'm gonna mark it again with our speed square and then similar to the outside corner and do it just like that so we're going to cut this i'm going gonna cut this these are metal benders flip it up like that flatten it out and you can cut it with the tin snips do with the grinder i'm gonna flatten it out because when you cut it with the grinder there's little burrs that can cut up your finger grab our chin snips i'm gonna cut that 45 straight over just like that i'm gonna grab the benders as you can see these are much more involved than the outside corner now remember the 12 inches we need is right here we're going to bend this tab down and fold it over just like that but we got this drip edge that's gonna conflict with this so what we're gonna do is we're just gonna notch it just a little bit so we're gonna slide that over you're gonna see this i'm gonna bend that over now someone can sit on top of your metal we're gonna have to cut these off so what we're gonna do we're doing some dangerous work you want to bring baby sister inside kobe get that piece off the reason we can't bend this over it's because it's the hem to drip edge it's double sided so we'll notch that again [Music] pull out our hammer just like that we hammer that one [Music] make sure our top is good and then bam that's your perfect inside corner if we want to throw our square on it it's perfectly square now same thing once you're done before this whole area right here [Music] you're going to want to add caulking right there fold it over now i like to bend it first and do a dry run and then add the caulking because there's no reason an added hulking if you messed up your cut so this is perfectly 12 inches inside corner so it'll go right here and be able to wrap that edge that's it guys let me know if you guys have any questions leave them in the comments below

Channel: Ethan Byers

Views: 21,877

Rating: 4.8601398 out of 5

Keywords:

Id: aNnbQdDNXwk

Length: 5min 46sec (346 seconds)

Published: Tue Oct 13 2020