outside corner flashing bend

okay we're going to make an outside corner show you how it is done your spots [Music] that's how you mark it with your square three quarters in on each side like so this is a three and a half inch flashing it's usually a little bigger than you normally use so basically that's how you mark it take your snips and then you cut it like this start at the center and i go to this point here pop down that make a little notch on the top like so angle down the reason you get that little cut so it follows the line up then you go back to the middle point all the way to the front like that this one comes all the way off this is you basically the front little snip there like that take your benders left so you just push it together like this see that then you flip this part over [Music] like this turn it upside down you can flip it around through that way underneath and if you want to go to an inside corner you just measure from there to the inside corner we can make that that's it

Channel: ted barnes

Views: 18,489

Rating: 4.6121211 out of 5

Keywords:

Id: LICg8M19IZw

Length: 3min 38sec (218 seconds)

Published: Sun Oct 25 2020