Finishing + Cutting Ends Of Roof Peak Flashing On A Metal Roof. EASY Install Video Peak At Gable

this is quick tips from the metal roofing Learning Channel brought to you by western states metal roofing where you could buy factory direct and save fifteen to fifty percent on your materials [Music] start by making a 1-inch mark along the edge of your trim from the one-inch line mark a 45-degree line at the drip edge on the top side of your trim mark the width of your gable trim you will then draw a line from this mark to the edge of your trim at the center of your trim cut a notch out to the one inch mark begin cutting along the following areas [Music] [Music] fold the remaining tab down 90 degrees for install guides color samples and more visit our Learning Center details in the description below [Music] you

Channel: Metal Roofing Learning Channel

Views: 23,566

Rating: 4.8811879 out of 5

Keywords: roof peak flasing, peak flashing, How To Cut The End Of Roof Peak Flashing On A Metal Roof, How to finish the end of peak flashing, peak flashing end cut, cutting the end of a peak trim, peak at gable, gable at peak, peak at gable metal roof, cutting the end of a gable trim, peak at gable install, cutting peak trim for gable trim, finishing the ends of peak flashing, finishing peak at gable, how to install roof peak flashing at the gable, metal roofing installation, peak trim

Id: hOo1TIJOyVc

Length: 2min 6sec (126 seconds)

Published: Fri Jun 26 2020