Guardian Tactical RECON-035 OTF Disassembly

all right well good morning I'll be doing a disassembly of the 30 in tactical recon zero three five is here I currently have seen no disassembly anywhere on the Internet of this so I figured might as well figure it out right so here we go I've already done this a few times it's not too bad so let's see hoping it wouldn't be much different like a micro tech or a little lightning OTF and it turns out it's not so that's good appears earlier first I'm taking apart they actually use a little bit red lock tight on these screws which is not not ideal but luckily I didn't have any strip any trouble get them off and these Torx bits also rt6 which is again which also is not a not ideal prefer to have like t8 or t10 but it works so I'm just Tammy's apartment kind of putting them in the orientation that I'm taking them taking them out it probably doesn't matter but you know I can't hurt this way so all right now there are three detent balls in here they're three detent balls in here two at the top one in the back luckily they are captured so it's not gonna be a big deal so you take it apart quite careful see there you go see two in the front one in the back and then for the spring bar here see them take it off here there you so there you go it's not too different it looks a little bit looks different than the do the ones you final microtext but it doesn't appear to work no I mean you different so that's good and there's what it rides in there focus there we go and then for the blade assembly so you have a lock here and basically keep it from moving forward and you press it now you take the blade out and then for the blade it's Lmax and this has a steel piece here it's been screwing with some red light on the back their system works well and yeah that's pretty much it lets you also just have this to get focused steel insert here see the detent pass on there taking focus you know there you go and then this just rides inside there and then the reassembly is not reassembly itself is not too much different from the way we did it take that put the steel insert back in there and set the blade back in all the way back in actually way I like to find it easier if you actually just disis you just leave the blade about halfway out kind of an untracked position it's a little bit easier do it that way don't you just take the spring bar here okay one minute I put it back together on let's see if you show me trying to get that back in the hole here alright so I want to make sure that both of these semi circles so my circle I want to make sure they're both facing the same direction so here's gonna clip on like that so it should look something like that J you want to leave this in about the half orientation here and just gonna put this on it off pot right here yeah take this and make sure that two balls in the frontal balls in the back it should be not at this point it's all put together and this should be moving because this isn't a on track position and then all we have to do here is just our screwed back on [Music] dude it hand tight right now I'll probably go back later in the applies and blue loctite zippy screws should be all complete here I only have to do [ __ ] to pull the blade out till the lock and then perfectly fine there you go have any questions about any eNOS hi digging this just feel free to leave a comment thank you have a good day

Channel: Bearsfan131

Views: 1,118

Rating: 5 out of 5

Keywords:

Id: t4ZwBHRHOSI

Length: 5min 54sec (354 seconds)

Published: Tue Mar 17 2020