Metal Roofing Flashing: How To Install Corrugated Metal Eave Trim + Drip Edge On A Metal Roof

this step-by-step installation specifically covers eave trim installation for an exposed fastener panel in this video we will cover require tools and supplies eave trim at a corner overlapping eave trim fastening eave trim and underlayment @e tools required metal cutting snips hand seamer carpenter's pencil and gun silicone we recommend premium ultra one thousand eight inch strip of sharkskin ultra self-adhesive and one inch metal to wood pancake screws prior to installation remove all plastic film installing Eve trim at a corner start by running the first section of each trim one inch past the edge of the roof then use your carpenters pencil to mark the underside of the eave trim by tracing the fascia and gable board use your snips to cut along the outline section of eave trim resulting in the removal of a one-inch flap as shown next remove a section of the hem by making a 45-degree cut to the 1-inch line use your hand seamer to bend the remaining one-inch flap backwards as shown this process will allow the eave trim to meet up with the gable trim and have a clean mitered corner repeat the process for the alternative side of the roof if trim is typically 10 to 12 feet in length and with most roofs larger than 12 feet sections will have to be overlapped eave trim should be overlapped a minimum of 3 inches this process is done by notching the first EEP trim 3 inches at the hem of the drip edge as shown next using a screwdriver slightly open the hem of the adjacent eave trim this will allow it to slide into the knotch section the purpose of overlapping is to create a secure fit on the fascia and secure it during windy conditions [Music] when fastening EEPROM use a one-inch metal to would pancake head screws they are low-profile screws that will not dimple the metal panel that will sit on top of it begin fastening first section of eve by placing two pancake screws on each end of the flashing eight inches from the edge as shown at the overlap apply caulking to the notched edge of Eve slide the second piece into the knotch section and secure it with two pancake screws eight inches from the edge as shown when measuring your final piece of Eve trim make sure to compensate for the three inch overlap and one inch needed for overhangs secure the final piece by applying caulking to notched edge and securing it with two pancake screws eight inches from each edge as shown [Music] place additional screws on each section of eath 12 inches apart on center as shown [Music] the final step of EVE installation is to place an 8 inch strip of self-adhesive underlayment one inch from the edge of the eave once this is done you will have underlayment both underneath and on top of the eave looking for more videos hit the like button and subscribe so you don't miss out on any future content for more information visit western states metal roofing com [Music]

Channel: Metal Roofing Learning Channel®

Views: 193,807

Keywords: eave trim, metal roofing flashing, eave trim for metal roofing, install eave trim, metal eave trim, how to install eave trim, metal roofing trim, drip edge for metal roofing, drip edge, how to install trim for metal roof, install corrugated metal roof, Eave flashing, Max-Rib, UnionCorrugating, MasterRib, install drip edge, how to install drip edge, Metal Roofing Learning Channel, metal roofing, Fabral, eave trim installation, install metal roofing, metal roof edge trim

Id: EGgrdIQCM-I

Length: 4min 23sec (263 seconds)

Published: Tue Feb 25 2020