Elegoo Neptune 4 Plus and Max homing issue quick fix (PLEASE READ DESCRIPTION AND WATCH PART 2!)

so if you've got an elu Neptune 4 Max or an elu Neptune 4 plus this video is for you if you're experiencing any kind of crashing when you try to home the machine out if the x-axis carriage or the y- AIS table kind of make a jarring kind of sound and the Machine kind of bangs into position when it tries to home that is something that can be easily rectified once you get the machine onto Wi-Fi what you'll do is you'll open up your fluid interface so you go to the IP address of the printer you go down to this little guy right here the configuration tab click on that go into your printer CFG and then what you're going to do is just do a contrl f to hit find here and type in driver SG th RS and you'll see right here this sgrs setting on this configuration this is set to 95 for the x-axis stepper and if we look here for the y- AIS stepper it's got got the same setting right here this is set to 95 as well your machine is probably more than likely set to an X of 40 and a y of about 70 and what you want to do is just turn those up make them about 110 and also the Homing speed for stepper X and stepper y right now they're probably set to 80 make them between 40 and 50 and then hit save and restart and that should pretty much solve the issue just wanted to do that real quick because I know that a lot of people have been asking about it and I figured I would just do a quick video about it this is on a Soo sv07 so my settings are a little bit different than yours would have been but the actual fields that you'll be modifying are going to be identical so just change those and then when you save and restart home the machine out again and that should fix the issue

Channel: The Feral Engineer

Views: 10,740

Keywords:

Id: aZOgE5m1ruQ

Length: 1min 53sec (113 seconds)

Published: Mon Oct 16 2023