4.3.8 Packet Tracer - Configure Layer 3 Switching and Inter-VLAN Routing

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
configure layer 3 switching and interview unrouting the addressing table mls multi-layer switch this switch layer three switch four belongs on this side and gigabit zero to the connection to cloud gigabit zero to the connection to cloud six pieces six pieces and three layer two switches okay configure layer 3 switching you will configure the gigabit 0 2 port on switch mls as a routed port and verify that you can pin another layer 3 address configure gigabit 02 as a router board and assign an ip address according to the other scene table okay gigabit 0 2 no switch port and the ipv4 others okay this interface and ipv4 address okay go to mls and configure this interface gigabit zero two the command line interface enter enable configure terminal interface gigabit zero two now switch switchboard okay no switchboard routed port the ip address and subnet mask ip address 209 to 125 subnet mask 252 okay the interface is already up a state to up so it's not necessary the no shutdown command because on switches the ports are enabled by default ping the cloud okay from pick the cloud and and to go privileged accent mode and pink the another side 209 165 200 226 the success configure interview and routing add belongs okay add villains to mls according the table below okay case sensitive this three belongs on mls okay configure terminal blank name staff vlan 20 name student bill anfield sorry bill and theory name fact will be case sensitive exit configure sbi on mls switch virtual interface configure and activate the switch virtual interfaces for belongs 10 20 30 and 99 according the addressing table okay this is the example for bill and chang with do for four belongs 10 20 30 and 99 interface with antenna okay ip address 192.168.10 254 subnet masks 24 enter interface state up not shut down not necessary and interface vlan 20 ip address 20.254 okay only ipv4 addresses okay for vlan 20 20. 254 for vlan 30 theory that 254 interface will figure the ip address theordia 254 and belong 99 99.254 interface belong 99 99.254 net mass 24 exit configure tracking on mls trunk configuration differs slightly on a layer 3 switch on the layer 3 switch the trunking interface needs to be encapsulated with the that one cube protocol on mls configure interface you can be 01 this is another side gigabit 0 1 on mls make the interface a static trunk port go to mls interface gigabit01 static trunk switch port mode trunk very good okay interface you go with zero one switchboard mode trunk specify nativila 99 switchboard trunk space t vlog 99 encapsulate the link okay with that one here protocol switchboard rank and capsulation dot one cube product okay and you will see this message because mls interface gigabit zero one on mls is configured with vlan with native language 99 but on s1 the another side gigabit 01 is configured by default with native language so native language mismatch configure trunking on s1 configure interface gigabit 0 1 of s1 as a static trunk okay this interface gigabit zero one on s1 access is one okay enter enable configure terminal interface gigabit zero one and [Music] a static struct switchboard mode trunk okay switch for more trunk okay inconsistent vlan okay the belong mismatch so fix this with switchboard okay switch switchboard trunk tip belong 99 enter okay configure the native line on the trunk okay is this okay for example go to mls and you will see this message poor consistency restore it so that is very good enable routing show ip root on mls go to mls the layer 3 switch and privilege excel mode show ipert okay empty okay are there any active routes the answer is no enable ip routing to enable routing in global configuration modes okay configure terminal on global configuration modes ip routing ip routing enter now repeat show ip root and xiao ip root and you will see five directly connected networks okay connected five directly connected networks four directly connected networks for vlans and one for the connection to cloud okay for directly connected networks for vlans and one for the connection to to the cloud verify end-to-end connectivity from pc 0 pc3 from pc 0 pc3 okay pc 0 ping pc3 ip address gender 2 when i do 168 template success from pc1 pc4 on vlan 20 from pc1 command prompt ping pc4 ip address is 20.2 182 160 168 20.2 success and from pc2 pink pc5 okay from pc2 pink pc5 pc2 command prompt ping pc5 192.168 here oda2168 theory that success from other one ping has two s3 okay from s1 okay one s1 and to go privilege excel mode and pin has two last two ip hours is 99 too big 192 168 992 success pick to pc3 99.3 from s1p as three 99.3 success and to verify interview on routing pick the devices outside the centers belong okay pc zero is placed on pc series place it on vlan 10 so you can ping pc5 pc 0 ping pc5 and pc5 ip address is theordee.2 on another network 3d.2 success picked the cloud okay for example from pc 0 pick the cloud ping 209 165 200 to 226 success the layer 3 switch is now routing between vlans and providing routed connectivity to the cloud configure ipv6 interview and routing layer 3 switches also route between ipv6 networks enable ipv6 routing on global configuration mode enable ipv6 unicast routing and do this on mls go to mls configure terminal ipv6 unicast dash routing enter okay this command very nice configure switch virtual interfaces for ipv6 on mls configure ipv6 advertising on switch virtual interfaces for vlan 10 20 and theory according to the addressing table this is the example for vlan 10 and go to address in table and configurant with this ipv6 address interface vlan 10 ipv6 address 2001 dba acad 10 column column one prefix 64. okay and vlan 20 interface bill and 20 20 column column one interface belongs here the 3d column column one okay no ipv6 on vlan 99 no ipv6 configure gigabit 002 with ipv6 on mls okay use this ip address for gigabit zero two on mls the ipv6 connection interface gigabit co2 ipv6 other s2001 dba acad a a current column one prefix 64. okay exit show ipv6 root to verify exit again show ipv6 roots space now you will see the connected networks one static root configured on the router uh is a per configuration and one directly connected network to three four four directly connected networks okay three directly connected networks four belongs in one directly connected network for the cloud okay three directly connected networks on this side on four vlans and one directly connected network the connection to the cloud verify ipv6 connectivity devices pc3 pc4 and pc5 have been configured with ipv6 addresses okay pc3 pc4 and pc5 configure it with ipv6 okay pc3 pc4 and pc5 using ipv6 pc 0 1 and 2 are not using ipv6 for now and from pc3 pick mls to verify connectivity within vlan 10 okay from pc3 ping mls vlan 10. okay go to pc3 okay pink and my last vlan 10 just the ipv6001 db8 acad 10 column 1 2 0 0 1 dba acad 10 colon colon 1 okay success from pc4 pick mls vlan 20 pc4 command prompt mls vlan 20 is this 20 column column one ping 2001 dba acad 20 column column one success from bc5 being mls milan theory from pc5 being mls pc5 command prompt pinch 2001 dba acad ac acid column mls billon theory ipv6 theory column column one theory column column and pick between devices pc3 pc4 and pc5 to verify interview and routing okay for example from pc3 pc4 okay go to pc3 and ping pc4 pc4 ip address is 20. 20 column column 2. okay 20 column column 2. ping from pc3 to pc4 okay enter success and from pc3 to pc5 pc5 is 10 column column 2. i think should be 3d column column 2 okay verify on pc5 okay fill the column column two okay the addressing table has an error should be theoretical on column two pc3 being to fill the column column to end success from bc3 pink the cloud 2001 dba ac id a column column two okay pc3 pink2001 db8d a column column two enter success completion 100 thank you very much you
Info
Channel: Christian Augusto Romero Goyzueta
Views: 6,310
Rating: undefined out of 5
Keywords: switching, routing, wireless, essentials, srwe, ipv4, switch 2960, switch, vlan, trunk, native vlan, trunking, inter vlan routing, layer 3 switch, multilayer switch, switch 3560
Id: MMha3L2s5OE
Channel Id: undefined
Length: 20min 3sec (1203 seconds)
Published: Sun Aug 02 2020
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.