RAGE-FIXing my Office Chair 😤🔧

hi you spend a ton of money go buy a chair with a bunch of handles and controls and then after like i don't know three four years it buckles under your weight can you even comprehend the nerve of the chair the stupid chair is fat shaming me don't make me make you cancel you piece of see the bottom of the chair is stuck in a forward position and i can't use the stupid handle anymore to push it back it's my new life now so thinking about i have to spend a ton of money to buy a new chair i was ready to accept my new life but then i thought none of the above i am an electrical engineer so i should be able to fix anything so i flipped this around and i realized that my fat bot has cracked this piece of rod in half can i even pull it out ah there you go this weak link wasn't able to handle my weight i guess now i make some measurements of this and see if i can replace it so i run to my local screw store with my measurements and i find exactly what i needed look at this it's a 5 16 of an inch thick bolt 3 inches long and has a long area of unthreaded screw and now how do we pull this out then i'll just pass the washer through it first and put this in somehow huh oh damn it i'm gonna get stuck here i can't use it i had so much hope i can't use this bolt on this chair what do i do now it's not gonna stop me it's nothing a little bit of side grinding won't fix i just have to see how far the thing travels inside to mark the place that i want to cut and now we cut it and hopefully won't affect the structural integrity of the chair too much so it won't bend under my weight and there's a bit of blood there you can ignore let's start [Music] i guess i can just bend it up [Music] a bit of damage to the bottom of the chair is the part of requirement now we fit the screw in like this let's hope we cut it properly we put another washer in here put on one of the nuts check and see if there is any interference doesn't look like it eh now we don't need to make this not super tight we just tie another knot on top of it then we tighten these nuts against each other that way it will never open and yet this ball can still move around freely in there there we go done like a charm oh fixed

Channel: ElectroBOOM

Views: 914,554

Rating: 4.964705 out of 5

Keywords: educational, electrical, ElectroBOOM, science, electronics, engineering, entertainment, equipment, measurement, experiment, mehdi, mehdi sadaghdar, arc, mishap, physics, Sadaghdar, test, tools, circuit, funny, learn, shock, spark, discharge

Id: LUcT7DERvHc

Length: 3min 56sec (236 seconds)

Published: Fri May 21 2021