Outback Steel Buildings: 25 - Install Rake Trim

Russia ting is fully installed you can install the rake trim along the edge of the building roof installed trim screw is to connect the trim to the roof sheathing per the installation manual and also to the N wall sheathing where the edge of the trim overlaps sheathing high ribs one trick section of this trim is overlapping at the apex of the building the underneath piece of trim should be cut at an exact 90 degree angle so that the trim overlaps correctly while the trim piece that is on the top will need to be cut at less of an angle depending on your roof pitch so that when it is installed it appears to have a vertical cut make sure to overlap the trim at the apex so that from the normal line of sight you cannot see the crease between the trim pieces also ensure that all upper pieces of trim overlap the lower pieces of trim so that the flow of water will never direct into the building

Channel: AmeriBuilt Steel Structures

Views: 49,880

Rating: 4.6989245 out of 5

Keywords: AmeriBuilt, 25

Id: qPlH3XvgqNA

Length: 1min 15sec (75 seconds)

Published: Wed Feb 05 2014