Installing BIGTREETECH SKR Mini E3 V3.0 in Ender 3 with Klipper

hello everyone as in my previous video we were able to verify that big three touch sqr mini version 3 is capable of running clipper via uart with raspberry pi 0w i just finished last configuration changes to make screen work we will install it at my ender 3 version 2 as clipper currently doesn't have clear and easy way to configure version 2 screen i will use under 3 regular screen what actually is good in this case because most of you probably will update regular ender 3 or under 3 pro with this new board due to silent stepper motors so next step i will show you wiring i will crimp few connectors and we will try to do a first print on this board [Music] [Music] i just finished replacing the motherboard this is my previous one 4.2.7 amazing board and i installed it before i just want to use this one in this printer extruder motor z motor why more i used za x modern my extruder fan extruder temperature sensor bad temperature sensor z stop actually named out there so you can figure out you can see what to put in here's the extruder heater bath heater and 24 input plus minus super easy super simple the only thing i had to do had to crimp one of the connectors for my fan because on an ender tree and the board you have just a screw in here is how everything looks right now i installed the board i did basic calibration for bad calibration and the hotend calibration i calibrate the extruder made sure everything looks right i set the offset and that's what we are running on as a new board i already see two benefits one of them when printer is not printing fans are not running also motherboard like a controller fan is not running if there is no printing which is unnecessary and that is very nice so you can enable the printer and if you are not printing you will not create any noise like basic collaboration easy steps you can do without even hearing your fans which is very nice the board is quiet of course it's a nice driver drivers so right now you can see i'm freaking the black line you see out there i used to had black filament i probably will have to do z calibration for this printer even more but that's the way everything looks maybe i will get rid of that uh screen i don't like it there is no reason especially if i can run everything from fluid pipe that's it for this video if you like it leave a like or dislike it dislike see you next one bye the first print is finished just a second ago let's see [Music] looks right i like those surfaces the black line is just from filament as i mentioned that's it perfect [Music]

Channel: Hobbyist Notes

Views: 26,377

Keywords: 3d Printer, Hobbyist Notes, BIGTREETECH, SKR Mini, SKR Mini V3, TMC2209, NEW BIGTREETECH board, 3d printer motherboard, Ender 3, Ender 3 mod, silent drivers, motherboard replacement, motherboard installation, BIGTREETECH SKR MINI E3 V3 0, #bigtreetech, Klipper

Id: wTQH5gkTo_o

Length: 4min 25sec (265 seconds)

Published: Thu Nov 25 2021