DIY Simple Hog or Goat Panel Deck Rail [Flipping Friday] Bonus

[Music] wow [Music] so [Music] [Applause] [Music] so [Music] uh just went in and checked my note that i wrote down and i actually this needs to be cut off at 41. and then we're going to put an inch and a half piece on so that'll get you above 42 and that's a good height for railing so i'm gonna have to readjust my lines here this 37 was how big i want my panels to be when i cut my when i cut off my goat panels that's what they call them they have 4x4 grid [Music] [Applause] [Music] so so [Music] [Applause] thank you so [Music] yeah we still this is a smaller skill saw so i've still got a little bit in there i gotta cut go get a sawzall and see if i can cut [Music] through [Music] [Music] [Music] so [Music] [Music] oh i've got my post cut here and there i've got all my railing pieces cut these basically i just is used to squeeze the hog panel together at the top and bottom and then we'll turn these on their side there'll be two right here then your hog panel and the piece on top and then there'll be two on the bottom squeezing that hog panel or else it's just too flimsy and somebody could fall through so we'll turn it outside put some screws in it to hold the hog panel in place and then um we'll put the whole piece of the whole section up on here it's gonna be heavy [Music] so i've got my panel made sitting on this deck i'm going to try to tip it up and then i got to lift it up so that i'm level here put a couple screws in it i don't know if i'm going to be able to do this alone so we'll see how it goes [Music] so [Music] looks like we're twisted of course let me show you what this is see that right there [Music] we've got about [Music] a half inch too much on this end so i either need to pull them screws out [Music] and shift it over or trim a little off look down here at this [Music] yeah it looks like this whole thing shifted this way i was just eyeballing it so and that's what happens when you don't measure corner to corner to see if you're square i came up with another idea i got a crowbar and a hammer i want to see if i can tap those this way it's like about a half inch [Music] and i got close but i think i'm just gonna trim [Music] [Music] oh [Music] well i kind of like it that way it would be nice for stuff to be able to blow underneath this railing that's why [Music] i'm just going to have just enough room to stick a 2x4 underneath there [Music] so maybe not [Music] there we go [Music] do [Music] [Music] [Music] what i want to do on the bottom is try to get if you look well you probably can't see but if you look from this direction this panel is kind of bowed it's bowing like this away from the deck so i'm going to try to use a crowbar and kind of twist it twist it back in on the bottom and then try to also center it at the same time [Music] [Music] so there's the finished product so over here where all this junk is down there is going to be the stairs going out kind of towards the driveway and i gotta put this other eight foot piece in but i'll probably do that a different day so

Channel: SchraderBoyz TV

Views: 7,536

Rating: 5 out of 5

Keywords: iMovie, Hog panel railing, deck railing, simple deck railing

Id: H1d18xB4saQ

Length: 14min 56sec (896 seconds)

Published: Wed Oct 07 2020