Crossfire XR plasma table cutting 16 gauge 45 amps 130ipm

hey guys it's me curtis schweppe uh just trying to dial in the settings on this new crossfire xr plasma table i'm using the razor cut 45 plasma cutter uh i got this silly little gag gift that i used to make on my old plasma table it's a little key chain holder but i usually just cut those out of scrap out of weird leftovers any place i can fit them and then i give them away as gag gifs but it's a neat little thing that's funny and a lot of people get a good laugh out of it and it's something good to test with to get your cutting speed and your amperage dialed in i cut one already it was cut at 45 amps and 130 inches a minute this is it right here a little more gross than i wanted so this time we're still doing 130 inches a minute but we're bringing it down to 35 amps see what that does um i got to lower that down a little bit and we'll be ready to cut let's see what we got here all right [Music] [Music] it's okay move that out of the way uh let me get the other one for comparison not much difference actually i think 45 amps was better hmm i don't know that's kind of a toss-up let me get this dry and we'll check it out

Channel: Schwoeppe's Shop.

Views: 5,372

Keywords:

Id: vwCu6Gdqo6g

Length: 2min 57sec (177 seconds)

Published: Thu Nov 11 2021