Creo Tutorial | Nut with internal thread | Soumen Sir

hello student welcome to my channel today we are going to learn a very important topics not with internal debt [Music] select talk then click on sketch sketch view click on palette click on polygons double click on six side hexagons click on this place please eat at center click on close click on apply change the size of the h20 click on ok click on extrude click standard orientation we've gone thickness height 20 inter click on apply' next next we applied select top plane [Music] select or clean click on sketch click on stage view click on reference click here click this age and this age click on circle click at Centerpoint click a circle with tangent this age click pocket [Music] click swept click on yet or edit Swift section click on schedule boy a tangle by using line click here click the angle 30 degree click online click here click here next click OK next remove material next up side next click on standard orientation click on datum plane click on top click offset height divided by 2 put 10 minus 10 opposite direction click OK now we have time here click this face select this face click select this face next we apply Muller command select this face then applied mirror command select the plane select obtain this is the middle plane select this fail then at side both side are swept now select top then click on sketch sketch view door circle click on center click circle diamond son diameter 18th click ok click on extrude click on standard orientation click on a remove material click OK next click on helical swept click on the reference click on define click select right then click sketch click on sketch bu click on the reference click on reference here we select the right side click on the reference click on this inner edge click close draw a line click here and here click ok click centerline click key 8 or edits wave section daughter circle two millimeter diameter put enter click OK click remove material click applied this is the internal state of a knot click on view double click on appearance gallery click on material click on part click ok this is the not with internal third so that was all for today if you want to know more about this copics or have any doubt you can contact me on my mobile number and if you like my videos do not forget to subscribe and share my video thanks my student

Channel: SOUMEN SIR

Views: 92,595

Keywords: helical sweep creo, how to use helical sweep in creo, creo thread, how to do helical sweep in creo, Creo Parametric 2.0, PTC Creo Parametric 2.0, New to creo Parametric, 3D Modeling (Creo Parametric), Creo Tutorials for beginners, Nut with internal thread, How to Cut internal thread, how to create thread in nut using creo, creo parametric 3.0 nut, creo internal thread, how to make internal thread in creo, soumen chakrabarti, Nuts, bolt, internal thread in creo, thread in creo

Id: B4IbNHFVAPU

Length: 10min 34sec (634 seconds)

Published: Fri Nov 03 2017