⛔ IMPRESIONANTE! 👉 TE MUESTRO Como hacer la MEJOR GUIA para SIERRA CIRCULAR casera 3 en 1

Threaded rod M8 x 95mm | Bearings 608 | M8 nuts 3/4 "x 1/8" iron plate We mark the Ø 9mm hole build the same as the previous ones It must be with a minimum slack We use a piece of 30mm x 30mm iron pipe tighten slightly assemble another one the same as the previous one Angle iron 1 1/2 "x 1/8" 30cm x 10cm 1.8cm phenolic An M8 nut must be hidden self-braking nut If necessary, loosen half a turn and re-adjust the nut where we made the mark assemble 2 equal sets 53cm x 13cm phenolic 1.8cm We mark both sides the same As I did the jigsaw SUBSCRIBE! :) 100cm x 60cm phenolic 1.8cm Iron spout 30mm x 30mm x 103.6cm M6 x 15mm milled head screw center the disc We make a Ø 6mm hole in the back of the circular saw drill and mill to place an M6 screw milled head Center (circular saw disk) T milling cutter iron plate 3/4 "x 1/8" To prevent the wood from flexing, we will use 1 1/2 "x 1/8" angle iron assemble both sides of the same shape If necessary we can loosen half a turn and re-tighten the nut where we made the mark so that the carriage slides smoothly Approximate center of the circular saw Angle iron 3/4 "x 1/8" x 12cm We make M6 thread This face must be well rectified Video PART 2: Cuts at an angle with these 3 elements PART 2 → | Recommended → | SUBSCRIBE =)

Channel: el Rincon de Vicente

Views: 4,102,908

Rating: 4.7530656 out of 5

Keywords: el rincon de vicente, rv, guia para sierra circular de mesa casera, como hacer guia sierra circular, como hacer una guia para sierra circular, guia para sierra circular casera, super guia para sierra circular casera, guia sierra circular, guia de corte, fabricar guia sierra circular, guia deslizante para sierra circular, guia para sierra circular de mano, guia para sierra circular, guia de corte para sierra circular, circular saw guide, como cortar recto sierra circular

Id: xYkUsN9Ug_M

Length: 23min 39sec (1419 seconds)

Published: Sat Mar 13 2021