✔️ GUÍA para TARUGOS de MADERA 👉 Plantilla para CENTRAR y HACER UNIONES con TARUGOS || DOWEL JIG DIY

iron plate 3/4 "x 1/8" x 10 cm we use any M4 screw to center holes equidistant from the center spawn the center ... and the ends of the opposite face drill stand we adjust enough, it should not be too loose or too tight we can also use self-braking nuts we use any wood that has rectified and parallel all its faces we rotate it ... we check that it continues to maintain the center subscribe :) 3/4 "x 1/8" iron plate we mark so as not to lose the original position bottom - top we use any M4 screw we arm respecting the marks that we made previously how to make a Jig Saw these holes must be enlarged to the diameter of the dowels to be used, in my case it will be 8 mm. We can make it 6mm, 8mm, 10mm or the measure we need We use 2 screws of the same diameter as the holes. In my case use M8 x 70 mm we use 2 pieces of melamine to calibrate the tool click to subscribe :) click to subscribe :) - recommended

Channel: el Rincon de Vicente

Views: 870,543

Rating: 4.8522096 out of 5

Keywords: el rincon de vicente, rv, unir madera con tarugos, plantilla para tarugos, plantilla para tarugos de madera, guia tarugos madera, diy doweling jig, dowel jig diy, guia tarugos, guia para tarugos de madera casera, guia para centrar tarugos, guia para poner tarugos de madera, tarugos de madera caseros, guia para poner tarugos, dowel jig, make doweling jig, guia para tarugos de madera, guia facil para tarugos, guia plantilla para tarugos de madera, guia para perforar tarugos

Id: NT_9WtILIzs

Length: 18min 0sec (1080 seconds)

Published: Tue Jul 28 2020