Making A $5 Fake Wine/Wiskey barrel from a single 2x6 | gift ideas | woodworking

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
in this video I'll be making a barrel out of a single two by six to start I cut off a six-foot section of the two by six to make the staves or outside pieces of the barrel I cut the round over off of one of the edges and then ripped the board into two two and 3/8 inch wide pieces next I cut each of my two boards into four seventeen and 7/8 inch pieces and now I'm ripping each mi pieces into three sixteenth inch strips I was able to get five out of each board so I ended up with three of these pieces next I did some bent lamination and I glued the pieces back together in sets of two and bent them around a two inch block as they dried and you can also see that I glued these up in batches to make things go faster now with all 20 of my pieces bent I could cut the bevel and radius on each piece and I did this using the table saw I used a strip of MDF to keep the piece flat as I fed it through the table saw with the blade set at 18 degrees and since the space between the blade and the fence is bigger at the top of the blade then it is at the bottom you can see it cuts the radius as well as the bevel on each piece next I glued all the staves together and hold each piece in place while the glue dried I used staples and once the glue dried I pulled out all the staples next I did a rough sanding with 60 grit to get off all the extra glue and ease the edges of where each stave needs I also glued some sandpaper to a flat surface and flattened the bottom and top of the barrel now I needed to make a rabbet on the inside of the top and bottom of the barrel and since I didn't have a small enough rabbeting bit I switched out the bearings of a flush trim bit to make an eighth inch ravening bit and use that on the barrel next to make the top and bottom of the barrel I cut what was left of a 2x6 from before into two twelve inch pieces I cut off one edge to get off the round over of each piece and then ripped the boards into 16 half inch strips I glued those strips together to make two 12 by 12 panels and then I used a card scraper on each panel to get off all the extra glue I traced the top and bottom onto each panel and cut it out with a jigsaw [Music] [Applause] [Music] I glued in the bottom piece and for the top I drilled a finger hole near an edge and just left it on glued so I could use the inside for storage but if you wanted to use this as a side table or stool or something you could just as easily glue in that top piece too and now I'm doing a final sanding up to 220 grit [Music] [Music] now to finish it I use some walnut stain to darken it and then put a coat of polyurethane over that to protect it lastly to make the rings that wrap around the barrel I painted some mule tape or flat rope black and just use some superglue to attach it to the barrel I was a little afraid that with the walls of the barrel being only about 3/8 of an inch thick it would be too weak but just to show you this could be used as a stool or side table it had no problem supporting my weight but my family is probably just can use this as an ottoman as well as just a place to store blankets in our living room you [Music]
Info
Channel: Josh Wright
Views: 417,976
Rating: undefined out of 5
Keywords:
Id: fYMJgvHAJ4w
Channel Id: undefined
Length: 11min 46sec (706 seconds)
Published: Sun Mar 15 2020
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.