HOW TO CONNECT ONKYO RECEIVER PT2 AUDIO CALIBRATION MIC

now after we turned it on and all that good stuff we want to do is just plug in the microphone that comes with it right here and it automatically toggle so I didn't hit any buttons it just automatically closed right there nice settings and then it's gonna ask you questions well in that questions button front speakers don't normal you want a powered zone too so yeah we're gonna have pull patio speakers and a speaker switch connected later on so we'll click on yes for that but if you click on yes for that what happens is you can't have some 7.1 anymore but if you click on no that becomes available 7.1 I tell is it right here see in the 7.1 could be the two more extra front highs or the surround banks so you get a put actually two more speakers in the front to make a seven point one or two more speakers in the back but we're not gonna do that we're gonna use that for zone 2 and to speaker switch so you can have speakers throughout the house all controlled on their volume knobs so now hit enter next and then we're gonna go ahead and do the calibration so we got to be quiet in the next like 30 seconds and then set up the microphone your level where you're listening areas here alright now that you had the microphone at your headrest where you normally say it next all right so now this is your setup right here you got the front highs you know the surround speakers just like that that's your setup so the because it did a calibration it knows what the configuration Spivak configuration is and all your flush my speakers are now calibrated let's go ahead and enter to save it and then enter again and it's telling you to unplug it that's it

Channel: TampaTec

Views: 60,541

Keywords: HOW TO CONNECT ONKYO RECEIVER, PT2, AUDIO CALIBRATION, MIC, SPEAKERS, ZONE2

Id: jJfB-AanpQs

Length: 3min 7sec (187 seconds)

Published: Sun Apr 22 2012