How to adjust the Z limit switch Creality Ender 3

when you bought one of these you had the same issue that i had when i was installing this one i skipped the part but here is the adjustment of my android 3 pro coming up on zuckery 3d prints hello this is zachary from zachary 3d print so last time i did an installation of this glass plate from reality it's a wonderful thing to use with 3d printing but however i got this little thing that i didn't mention quite well on my last video on the installation i did say something that i've done on my on my end stock but i didn't share anything about it what i did or how i did it so thank you ma for pointing it out so here is the video how you can adjust your install to use this clasp so as you can see there is a difference between the two printing surfaces the stock print that the magnetic pad it's it's quite lower than the glass plate i can use the caliper and it would say that my print bed is just one millimeter thick but however the glass plate it's almost four millimeters so there is a difference of three millimeters yeah just so last time in the video i tried to adjust the bat by using the the thumb screws and it didn't work i had to do something with the handsaw now i'm going to cut the chit chat i'm going to show you how exactly you can do the same thing i have adjusted the camera so that you can clearly see the end stop and as you can see i just put it on the stock level here i'm going to use that part of the chopstick that is something like the same height as my glass pad so as you can see it's now like that and now we are going to adjust the height of my bed so now we are going to level the bed this is the way that i used to do this but if you have some other ways then feel free to do that so just going to the first corner that's not the way you want it so a little bit down now we take this piece of paper as always what i use for this sneak that needs to grab it like this that you can also see it here's too much pressure so i need to do it a little bit down oh there's too much down put the camera a little bit backwards so that you can see what i'm doing it's sitting again be careful not to scratch the bat impressions is i still had a calibration cube on my uh sd card um i'll leave it printing now so that i can see where are the flaws in leveling the bed but as i i'm watching i did turn the dial a little bit backwards so it had to take some time to get the filament out of the hotend and now it's uh it's it's printing and it looks pretty nice making adjustments on your hand stop on your end of three or your energy pro or your cr10 it's not that difficult just a little bit higher and then you got enough space to make that level that being said thanks for watching if you're new to this channel please subscribe to my channel it will help you quite a lot with your 3d printer or 3d prints or other things that has to do with 3d printing and please like this video thanks for watching and i will see you next time happy 3d printing zafari 3d prints bye

Channel: Zachary 3D Prints

Views: 96,853

Keywords: Zachary 3D Prints, Creality, Installing Glass bed Ender 3, how to adjust z limit ender, Ender, Creality Ender 3 glass bed, Installing Creality Glass bed, Installing Creality Ender 3 Glass bed, How to install creality Ender 3 Glass bed, Getting 3D print easy of print bed, How to instal glass Bed Ender 3, How to install Glass bed Creality Ender 3, How to install glass bed Ender 3, Glass bed installation on 3D Printer, Glass bed, CR-10, Pro, review, Zachary 3D prints, creality ender 3

Id: bGGNlHkuLX4

Length: 6min 46sec (406 seconds)

Published: Fri Oct 25 2019