Hello, this is OAzone. Today, I will show you how to disable it with Canon Pad Reset Service Tool. Canon product If you look at this page, the power button and the alarm lamp blink alternately. The pad is full. You can solve this with a program. I'll print it out on the PC to check the status. I'll bring it to the pc and check the nozzle in properties.
(In Windows 10, Devices>Printers and Scanners>Click Model Name>Manage>Printer Properties) I'll print it out on PC first.
Maintenance>Click Nozzle Check>Click Print Check Pattern If support code 5B00 appears when you press print like this, the waste ink is full. Yes If 5B00 is displayed like this, 5B00 is the pad reset. To cancel with the pad reset service tool, you must enter the service mode before running the program. To enter, turn off the power first. In the off state, press the power button and the stop button at the same time. Press and hold the stop button five times one-two-three-four-five and release When the power blinks like this, the service mode is ready. You can solve the 5B00 error by executing the program only in this prepared state. So it blinks and stops. I'm going to reset it in this stopped state! Go to PC and click Settings-Update and Security. Security recognizes this file (pad reset program) as a virus and deletes the file. If you have anti-virus programs such as pills, V3, etc., be sure to delete them, and then unzip the pad reset program so that the pad reset program cannot be deleted. Please run the service tool program. I have a hardware ID. This is your PC number, so copy it and paste it into notepad. Copy the ID, enter the name in lowercase st, and send it to the key input location. If you send it to the authentication site, enter the hardware ID and name and then issue a key number. Copy. This is the authentication key Copy it to notepad, organize it, and enter it again in the program key corner After that, when you are done, you enter this number in the key corner. Because I copied it to the place where the letter key is written. If all three are entered, click Register. Then the program will run. yes you can reset it here I joined the service tools program. In this state, put it on the main ink Absober Counter and press Set. Then A Function was finished. Then you need to go to the device and turn the power off and on. When done, turn off the power. It takes a while for the power to turn off, so wait and then turn it back on and if the light doesn't come on, it's normal. If the light stops, I'll test the output. I'll go to the pc and find the driver, then go to maintenance and print the nozzle check. If the reset is successful, this error message will not appear and it will be printed from the device. When finished, the device that was not working will work like this. It comes out beautifully. Please like and subscribe!
