Hello, we're O.A.ZONE! Today, we will learn how to clear the error with the Canon Padreset service tool. If the power button and alarm lamp alternately blink, the pad is full. You can solve the error with the program. First of all, I'll print out a test to check the condition on the PC. Let's check the nozzle in the properties of the PC. (Device > Printer and Scanner > Click Model Name > Printer Properties) (Maintenance > Click Nozzle Inspection > Click Check Pattern Print) If you press print and the support code 5B00 comes out, the waste ink is full. If you get a 5B00 error like this, you can set the pad. To turn it into a padricet service tool, You must enter service mode before turning the program. Please turn off the power first to enter the service. Press the power button and the stop button at the same time while it is turned off. Press the power button and press the stop button five times before releasing it. The service mode is ready if the power flashes. You can solve the 5B00 error by running the program only in service mode. The power button flashes and stops. I'll reset it while it's stopped. Because security programs recognize the padricet program as a virus and delete files, Please turn off Windows security real-time monitoring before running the program. If you have a vaccine program other than Windows security installed, Make sure to remove it or turn off real-time monitoring before running the program. This way, the program will not be deleted. Please run the service tool program. Canon - Select the installed printer and click Start at the bottom. (The program on the current screen is not connected to USB) (Serial number is not available and the program is not activated.)) (When the USB is connected, the program is activated with the serial number at the top of the program.) You can reset it on the screen. I ran the service tool program. Set Ink Absover Counter to Main and click Set. The reset was completed with the A Function was completed. You have to turn the power off and on. Please turn off the power. (It takes time for the power to turn off.)) If the alarm lamp does not blink when the power is turned on again, the reset has been completed normally. We will print out the test when the power lamp blinking stops. Please print out the maintenance-nozzle inspection that I showed you at the beginning of the video on the PC. If it's reset well, there's no error message. It will be output normally from the device. Once completed, the device will operate normally. It's being printed cleanly and well. Please subscribe and like it. Thank you.
