Electric GUITAR made of GUITAR PICKS and Epoxy Resin

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
18mm MDF board I refine only one of the 3 boards of the mold The rest are going to be refined on the router table Underneath I use a melamine board, I seal it with silicone. Before starting to place the guitar picks, I pour a 4 or 5mm epoxy layer I scuff the surface lightly so that the cyanoacrylate and the next casting will grip Now it is a matter of placing the picks one by one gluing them with cyanoacrylate They ended up being about 4,500 The next thing is to encapsulate everything with epoxy resin. While the resin hardens I am going to make the maple neck. I cut the headstock at a 10º angle and leave it at 14mm thickness In order to not to move the headstock during the glue up I'm going to secure it with 2 screws I plane the top face to make it perfectly flat. I'm also leaving one side flat and perpendicular so I can rout the truss rod channel The fingerboard is made of pau ferro wood The scale of the instrument will be 25 " Here I am preparing the headstock plate, it is cocobolo. With a jeweler saw I cut access to the truss rod The fret markers are going to be shaped like guitar picks. I am going to mill the recesses and fill them with epoxy resin and white pearl pigment. Now is the time to glue the fingerboard. The fingerboard needs a 12 "radius, I'll end up sanding up to 12,000 grit for a polished finish. I can now carve the neck, I will use rasps, the spokeshave and the cabinetmaker's scraper as always The side dot markers are made of 2mm diameter white plastic stick, I glue them with cyanoacrylate Now it's time to fret the neck We already have the neck, now it's time to go back to the body. In the end everything went quite well, I thought it was going to be a lot harder. With the angle grinder and a sanding disc I make the belly comfort carve. The next thing I want to do is mill the cavities for the neck, pickup, and electronics. Milling this material was much more complicated than if it were wood The chips were flying everywhere Now what we have to do is sand a lot. The neck is going to receive 5 coats of tru oil The body is going to be different. I am going to sand it up to 2000 grit lubricating with soapy water. Then I will polish it first with medium compound and then fine I'm going to make a Humbucker with a 12Kohm resistance and an alnico 5 magnet It only remains to assemble everything, electronics and the setup The electronics are very simple, a humbucker and a volume knob. The electronics cover is made of transparent methacrylate, so you can see inside picks pattern It is already finished, I hope you liked it, next you have the demo. Thank you very much for watching the video, do not forget to subscribe if you are not already.
Info
Channel: Noe Hervas
Views: 8,368,639
Rating: undefined out of 5
Keywords: guitarra, guitarra electrica, RESIN CRAFTING, resin art, resin art maker, how to use epoxy resin, diy guitar, diy lego guitar, guitar project, electric guitar build, electric guitar, statocaster setup, Pick guitar, resin guitar, noe hervas, how guitars are made, plectrum guitar, guitar build, guitar building, como hacer una guitarra electrica, epoxy resin guitar, how to build a guitar, luthier, full guitar build, building a guitar, woodworking, asmr
Id: bYIyknWbdLM
Channel Id: undefined
Length: 30min 54sec (1854 seconds)
Published: Tue Sep 28 2021
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.