DIY PCB Toner Transfer (No Heat) & Etching

[Music] [Music] onto the copper board I use magazine paper just a local supermarket magazine pages of glossy the only thing it will transfer onto the copper board from when your prints on this is the actual toner so it's ideal so we'll go ahead and place one of these over this image even though it's gonna prints on the right place so do the same for the silkscreen layer [Music] [Music] a bullet off it all I'm all dirt off make sure it's nice and shiny I just use the scotch pad and then it's putting this face down over that image I'm sure your lines are this boards a bit small what I need well it's just enough court got for this video I'm just using masking tape [Music] I can tell you so we transferred it's for the image onto the air the copper board is this nail varnish remover or nail polish remover it works absolutely fine I used to use use on silkscreen layer unless decide to give it go on the copper board layer save all the time of iron in and heat transfer and it works so let's give it a go make sure it's all spread out and roll fairly hard across all the area you don't apply enough pressure then it may not transfer correctly on I've done this a few times and just not applied enough pressure you feel that sounds are dry and that point I stopped then inside it dry a bit [Music] [Music] [Music] you transferred off the magazine paper streams the Kefauver know when it starts drying you will get a bit of white tinge that's just a few fibers of the magazine paper all I do is just a damp sponge [Music] time ready for action he's an ferric chloride I'm ready mixed and I'm have another problem with this I know there's other ones out there people make their own which all my time to go up at some point but that works for me it's put in a small dish as a board nice pop it in [Music] [Music] [Music] [Music] [Music] [Music] but is fully acts now so just rinse it in water on to the next stage [Music] just using no heat transfer method subscreen lying on the reverse so I looked on on double sided boards I've never had a problem to go on this time the coppers itched away it's been a rough fiberboard but on single sided boards live at Sur just roughing it up slightly with a bit of wire wall just give it a bit of a key to be honest so [Music] [Music] [Music] [Music] open a paper on it from magazine but again just damp sponge water you can use lovett of nail varnish remover just get rid of the block off the tracks or steel wall or whatever you want really to vanish or incense you just what with a steel wall it's better to and pretty robots you can scrape your fingernail across it will not come off a sharp object will bring it off or my sharp object would bring anything off at the end of day means it's definitely good enough I think for a DIY person and you got a fairly decent professional professional job from it there we go [Music] there we go on each board and the salt screen board about using any heat transfer methods just hatched so there's only flashing LEDs and in spectacular does programmed from an app maker free to each cleaned up a bit better no one's there to hums say all the trucks are really good on it I'm happy it's nice and quick approach thanks for watching I hope you've enjoyed this give us a thumbs up if you liked it thumbs down if you don't and any comments please feel free

Channel: Gareth Burrows

Views: 1,148,953

Keywords: PCB Printing, PCB etching, PCB Transfer, PCB, PCB no Heat, DIY PCB Printing, DIY PCB Toner Transfer (No Heat) & Etching

Id: cVhSCEPINpM

Length: 12min 11sec (731 seconds)

Published: Fri May 11 2018