Building a Wooden Stand for My NC Tool Round Horn 82 Anvil!!

hey y'all it's trying to Blood Mountain craftsman again and today I'm gonna be building an anvil stand for my NC tool 82 pounder I got these plans from a YouTube video from purgatory ironworks I make sure and link the video in the description I just cut out seven pieces of 2 by 12 which will make the bulk of the anvil stand and then the rest of the hardware I have 4 12 inch long pieces of all thread they're half-inch diameter and then I have 8 washers and 8 nuts as well here's the rough plan I'm actually not using the 9 2 by 12 so it was just gonna be too long because the base of the anvil is only 10 inches 10 inches long our next step is gonna be to I'm using a 5/8 spade bit on my drill press so we're gonna start off using our combination square so that's 2 inches and put the holes 2 inches in to either side so right here too much is from here [Music] do that on all four corners that's what we're going forward ride there alright y'all there she is one final step oh man not too bad hey y'all just want to say thank you for tagging along today it feels great to finally have this stand built for this NC tool amble and talk to you again real soon

Channel: Blood Mountain Boys

Views: 3,210

Rating: 4.9354839 out of 5

Keywords: anvil, anvils, blacksmith, blacksmithing, blade, blades, bladesmith, bladesmithing, craftsman, craftsmanship, forge, forged, knifemaking, machining, machinist, machineshop, metalworking, shop, sword, swords, tools, welder, woodworking, YeeYee, BloodMountainCraftsman, anvilstand, woodenanvilstand, stand, nctool

Id: 5d6jW8nwmWA

Length: 3min 25sec (205 seconds)

Published: Sat Jan 25 2020