Audi TT gets the LC Wraps makeover! wrapped in Avery Dennison fun purple

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
hi guys and welcome back to the Channel first of all i' like to say a massive thank you for all the love and support you've given me after having my feature on the animiz YouTube channel I really do appreciate all the messages I've had and all the new subscribers off the back of that video so I hope you're going to enjoy the content and join me for the journey so what's today's video going to be today's video is going to be a full wrap on Andy higgins's Audi TT in Avery Denson fun purple and it's right outside that shut now ready for you guys to see I've done a few time lapse videos on it so obviously all the panels I've done you'll be able to see it but I haven't done much talking to be fair cuz I've been so busy and just wanted to get this car done so yeah let's take a look outside now and uh go see the car hold up we need to watch the wrap first so let's start this car wrap with the wings first obviously we give the wings a good clean and then after we've cleaned it we go over with a heat gun to make sure there's no wet edges we place the film onto the wings with the AY Denon up and then we try to Glass the wing all in one before we squeegee [Music] so once both wings were done I then moved on to the Sills I've removed half the backing paper and tacked my side into position and then proceeded to lay the vinyl onto the flat part of the sill moving forward and then once the front section was done I then moved to the back and worked into the recess area [Music] and then once the top of the sill was laid I then proceeded to heat the vinyl from the body line and stretch it underneath the S so now we move on to the rear quarter but to make sure the overlaps are the right way I have to wrap the boot return first so here I am sitting in Andy's boot [Music] so guys it's now time to lay the rear quarter as you can see the rear window the rear bumper and where the light would be and also the petrol cap is all taped up this is to minimize any contamination underneath the WRA we then proceed to cut any excess off the rear qu that we deemed not needed so to start laying this rear quarter I remove a little bit of the backing paper on the front section and then I attack the vinyl to the wing I then proceed to roll the backing paper this is again to minimize contamination and also make it easier to handle as I roll back the backing paper to release the vinyl I then proceed to lay the flat section of the rear quarter working it to the recess area [Music] [Music] I then proceed to the lower part of the rear water but I have to heat the vinyl from the body line and pull it down in one swift motion I then have to fire in the recessed area of the rear Arch and then Chase my air up to where the door would be [Music] I then proceed to finish laying the pillar [Music] area as I lay the vinyl into the rear quarter shuts I get Andy to hold off the vinyl to create a bag so I can feed the vinyl into the recesses as best as I can [Music] [Music] so with the rear quarter now wrapped I then moved onto the hinges this is not something that you see every day and to be fair not many rap shocks will do this for you but it's something I like to do to go the extra mile for my customers [Music] now we're on the door returns once we get these wrapped we can then put the doors back onto the vehicle [Music] [Music] [Music] now to wrap the faces of the doors I tap the doors in position with some masking tape I then hinge the door from the middle and Tack it to the body line and then squeeze you my way up to the top I then pull the backing paper down heat it from the body line retension the film and then squeeze you down once I've done that I then tackle the recessed area of the hle [Music] so so we're on to the front bumper now I'm awful sorry for the camera angles my bad I honestly didn't realize when I was recording however how I wrapped this bumper was I used niest tape and did one inlay and then just used one piece with the face after that [Music] so now we're moving on to the boot lid I start off by laying some preas to the rear qus to save the vinyl from tapping to it and then lay some knifeless tape around the window so I can get a decent HCK behind the window and then also I remove the excess from the window so I can keep that vinyl for mirrors and handles Etc you never know when you'll need some [Music] spare so I want Mile with this car and I actually wrapped underneath the spoiler I quite enjoyed doing it to be fair feeding all the vinyl into them recesses [Music] [Music] so guys it's the last piece of the puzzle now the rear bumper so how do we do this basically I get Andy to hold it in the middle to create a hinge I then remove half the backing paper pull it around and Tack my side and then proceed to do the same on the other side once we've done that I then pick one side back get handy to hold that end while I heat the vinyl and then pull it up and down to tension it and then pull it round onto the bumper so once the vinyl's been pulled round onto the bumper and give off the glass effect as we say we then have to fire it into the three recessed areas and then proceed to squeeze you the vinyl down onto the bumper [Music] [Music] [Music] [Music] trying to get the shots herei Masterpiece mate it's a masterpiece [Music] [Music] n [Music] w [Music] so guys this is Andy's Audi TT which I have wrapped in Avery Denson fun purple and I tell you now you'll never know this car was n or gr we have wrapped absolutely everything we'll do a quick little walk around and show you what we rock so we'll start off underneath the bonnet so we actually wrapped the structure of the car so when you look in the engine bay it's all purple the only thing we haven't wrapped on this car is underneath the Bonnet so we'll move on to the side so we've done full shut and Returns on this car and then also we've gone the extra mile and we've actually wrapped the hinges if you want to take a little look at them so then moving on to the back we've also done the boot returns which not many companies do I'll be honest so when you lift off this boot everything inside is wrapped and as Andy's just shown you even the hinges I'll tell you now you try to find another company that'll wrap them for you this is a war off this oh also if you can see it in the light underneath the spoilers all been wrapped we finished it off higgins's YouTube here so go give him a subscribe subscribe W so guys that's the end of the video on the Audi TT drop a comment below and let us know what you think about the wrap peace is that your video done yeah yeah 10 10
Info
Channel: LC_Wraps
Views: 1,760
Rating: undefined out of 5
Keywords:
Id: AzV_VZFmWrY
Channel Id: undefined
Length: 17min 36sec (1056 seconds)
Published: Tue Apr 16 2024
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.