2021 Husqvarna TE300i or FE350 or both.

hello everyone and welcome to the sunny okanagan kelowna british columbia beyond max enduro youtube channel these are my two rides for 2021. in my opinion they're the best uh two bikes you can buy for a hard enduro i have the te300i two-stroke and the fv350 four-stroke both bikes are set up with craft moto suspension out of bend oregon the te300 is set up on soft plush and the fe 350 is set up medium for higher speed riding uh amongst that there's some other extras i have on the bikes so the te300 has the fmf exhaust tip as well as the header pipe graphs kit done by lime9 out of kelowna custom graphics they do a great job very durable graphics [Music] you see here i got the hinson clutch cover there's not only more durable than a stock one but it also holds approximately 100 mils more of oil which is a good thing to have in your clutch pack moving over the steering i've got a skier scott steering damper with a brp handlebar mounts got the solid rear disc for uh the spring riding my time of year the rear tire is the shinko 525 cheater and the front tire is mx216 cheater tire skid plate by emperor racing as well as the rad guards moving around got the disc protector a little bit of bling bling there gengar bling bling got the polar sport ignition cover just for the eye to protection in my opinion this is the best hard enduro bike in the world right now moving on to the fe350 i went with the upgraded led headlight front tire is the mx216 with the nitro mousse medium i went as well with the henson clutch cover for durability obviously and then extra oil this bike's basically the same setup so it feels the same other than the power so i got the scott steering damper or the brp handlebar mounts and i removed all the fuel the fume recovery system the missions on this thing and i also pulled the reeds out of the air box uh slavin's racing has a kit to pinch off all the nipples that normally had the fuel lines on and remove the vacuum valve and it had a dongle in there to plug into the electronic portion of it so you check engine light wouldn't come on so it run properly and my understanding is you can do this if you've got the o2 sensor it'll make all the adjustments needed for this bike to run properly 525 cheater in the back with a nitro mousse soft which is supposed to mimic six to eight pounds of air pressure in a normal conventional style tube i've also got the polar sport ignition cover on this as well and i went with a few products from as3 out of the uk they make very good quality parts and they're very well priced the levers here our as3 look at these nice bleeders bleeders get off the air there you have it fv350 and te 300i till next time thanks for watching

Channel: MaxEnduro

Views: 5,975

Rating: 4.6923075 out of 5

Keywords:

Id: bcvunTYtOJ8

Length: 6min 7sec (367 seconds)

Published: Sat Mar 06 2021