Hello, I'm OAZON Today, Samsung SL-C513, (510 is the same) I'll remove this product's paper pass Remove and replace again It's the reverse order of removal It's for consumables, toner, and so on I'll take out the warrior belt and drums If I open it first, there's toner, so I'll take it out first You can take it out like this Yellow toner Red This is a genuine toner with Samsung logo This is called a bundle toner Toner has been removed And this is a waste toner container If you pull it, it'll come out It's a new one without a waste toner Now And if you pull it... The drum will be separated Let's take the transcription belt apart Take this out and turn the back... Undo what's on it I loosened the back and came back to the front Pull it and take it out So, the belt has been removed Unscrew 4 screws on the back And then if it's all separated This is paper pass. I'm going to separate this NASA's gonna remove these two Before removing the screw I'll remove the cable first Starting with the wide board on the right I'll remove this cable If you look inside the board There's a red and black cable connected You have to take it out It's this And the other side, too The one that's tied up with cables You don't have to take this out, but since it's tied up, you have to take it out first It's tied up like this, so take it off Untie this part to take it out Undo it so that you can get out You just need to loosen it up and leave these three strands You can put this back in Unscrew the screws and pull them out of the way I'll try it The screw is hidden on the board, so I'll untie the board The screw above the board is small And the bottom part is big You have to tell the difference I'm going to take out the board gently If you open it, there's a screw inside I'll loosen the two screws It's black Yes, I'm done with this side. Turn it around I'll loosen the screws on these four spots And the top I'll remove the two screws I've loosened the screws, and I just need to remove them, thinking about the cable Pull it gently toward the floor Pull it and let the cable come out Pull it Push it from the inside So that the cable comes out This side is okay. This side is also... I'll push the cable first One by one You have to take this side out, too Like this, it comes out this way Yes, there are four cables separated like this And in the case of paper pass, there are three strands The three strands are the same, and sometimes red is added In this case, it depends on the board If it's a board that you can plug in, you can plug it in If there are no seats as below All you have to do is plug these three strands in You can put it in this position This side is the same This was how Samsung C513 Paper Pass was separated
