Vacuum Pressure Hydrogen fuel cell defeats high gas prices using hydrogen from H2O.

making fuel from water is extremely easy much more easy than they would like you to believe this is just water electricity and some baking soda and about 29 amps we found that we can inject this in the state of vacuum into our engine and double our mileage under certain circumstances I'm running a v8 350 and have been to over 30,000 miles it all starts with the wiring you get some number 10 gauge wire 2 conductor and run it to a switch which foot under your dash I am using a regular 120 volt light switch which is rated at about 20 amps at 125 volts I'm only running and about 13.8 volts DC the switch has not worn out or burned up yet where it seems to work flawlessly this is the ground wire that I connect to my frame if my battery was over here I would have put it to my battery just for convenience now I'm gonna set the jug right here next to the master cylinder I just happened to have room for a gallon jug this is the vacuum line that goes to your carburetor this is the master cylinder here that is your brakes controls your braking so we're going to take advantage of back and pressure of the engine right here where its strongest can get like 16 inches or more of vacuum at certain times and we're going to set a pad here and install the jar right here we're going to put about 3/4 full on the water and I've already added some baking soda to it as an electrolyte now this is a very fancy cell element design Dobby don't be disillusioned by how fancy this looks because very simply you can get 3 face plates of high-grade stainless some teflon nuts-and-bolts and for about 5 bucks you can make this you have notched it for the wires put the positive in the middle but the negatives on the outside and boom got it I've just made a more advanced version you run the wires through the lid like this install this down here and we're gonna seal this up and we're going to show you how this thing produces gas this is the positive wire which I run to the alternator I've installed a 30 amp Auto reset fuse on both sides positive and negative so I have redundant fuse protection in case of current overload and the fuel cell will occasionally pull too much power we wanted to automatically shut off we connect to the alternator because we have a lot more magnetic field right there much more energy available than connecting it to the battery so I highly recommend that you connect it exactly as you see in this fashion this is the dryer jug it's just another jug that's sealed off that has a particular way of plumbing one long hose which goes to the fuel cell the other hose barely in the jug which goes to the vacuum system of the engine you put it down in the jug and the overflow is automatically sucked back up into the other fuel so we've used poster putty which is liquid Teflon as a sealant it is the most recyclable thing you can use you can use it over and over and over its poster putty and it's the brand name for it don't endorse any products but I don't have a choice it's really the best thing you can use plastic hoses is what we use on our vacuum pressure fuel cell it is part of the thermodynamics of the entire process again poster putty placed around the hoses on the vacuum pressure fuel cell in the state of vacuum will suck into the small crevices and will not allow leakage it has been working flawlessly for many years on my vehicle I have over 30,000 miles running on the vacuum pressure fuel cells so far and my engine performs incredibly well it's a little tacky at times when it gets hot it will really seal well this shows you some of the production in the vacuum states that's a lot of hydrogen oxygen gas it's enough to actually cool the water there's 25 amps right now flowing through there and we want to run it as close to 30 amps as possible you can see a tremendous amount of gas it will actually produce even more hydrogen and oxygen gases the engine gets going the RPMs are high and the magnetic field is coming off of that alternator baking soda Arm and Hammer highly recommended it's the only one that won't foam up cheap stuff you'll end up with foaming in the water and you don't want foamy water it's gonna have some nasty buildup eventually but don't worry it's not a problem in the vacuum pressure fuel cell the extra dryer jar in front takes care of anything that would fly into the engine it's a very interesting system and has been used for many many miles a lot of people sell this for hundreds of dollars you can build it yourself for about 55 dollars in parts most of that is fuses and wires and it is important that your alternator is able to handle the current it will pull about 29 amps so you have to make sure that your alternator is in good condition you get this thing hooked up right you should see water coming out of your exhaust as he gets going the amount of water coming out tremendous paying on your engine if you have any carbon buildup or nasty stuff in your engine it will generally blow out right onto the ground in front of your eyes steam cleaning the engine this is definitely a technology that has potential we hope that you take advantage of it thanks for watching [Music] [Applause] [Music] [Applause] [Music]

Channel: Metalpress TV

Views: 1,872,620

Rating: 4.7587185 out of 5

Keywords: Vacuum pressure fuel cell, hho, quantum physics, free energy, water for fuel, hydrogen, run car on water

Id: wxfo-w0ptEo

Length: 6min 23sec (383 seconds)

Published: Tue Apr 05 2011

Reddit Comments

[u/crustang]

Breaking traffic laws is old news, breaking the law of conservation of energy is where it's at

[u/alle0441]

TIL: I get much more magnetic field directly from the alternator.

[u/A1Skeptic]

HHO Ho Ho Ho! It's magic gas that makes cars Go Go Go!
Save big money and the environment with our HHO "Conversion" Kits, @ only $69.96.

/Kit includes jelly jar, a few feet of wire, a stainless steel scouring pad (cut in half), almost three feet of vacuum tube, cheap plastic fittings, and a few screws./

[u/Andysmith94]

wait... is there actually a hydrogen fuel cell in here? Or is he just putting hydrogen in the engine instead of fuel...

[u/zerohourrct]

The theory behind this is actually pretty solid: the electrolysis process is pretty efficient; most of the energy is recouped in the recombustion, and you could get more efficient combustion by changing the intake gas composition. But I've yet to find any valid analysis on actual results, and it would vary considerably from engine to engine and various operating conditions.

[u/JimmyJames008]

Is this video real? I know there is no energy savings or fuel cell, but the electrolysis of water rate is insane!

[u/DollaBillMurray]

These setups don't generate hydrogen gas. They tell you to add baking soda to the water (NaHCO3) and the bubbles you see forming are actually CO2. This only makes it harder to burn the fuel.

[u/COSMIC_SPAGHETTI]

Instructions unclear, got my dick stuck in the magnetic field of the alternator.

[u/SilverbackRibs]

Use only plastic tubing. Cause its part of the thermodynamics