Step by Step Upload Code to WT32 ETH01 from Arduino IDE

hi welcome back to my channel in this video I will demonstrate step by step how to upload code to the wt324 communication using an ethernet [Music] cable to learn more about this device please visit its official website and you can also download the data sheet for further information [Music] [Music] since the wt324 computer uploads we need an additional device the TTL to USB uart this device is used to connect Electronics that use TTL level serial communication to a computer via a USB port the pins we will be using are RX TX 5 volts and ground I'm also using a mini project board and some jumper cables before we begin don't forget to like And subscribe thank you here is the wiring between the TTL USB and the wt324 wio IDE first connect the RX pin on the TTL to the TX pin on the wt324 I make sure to cross the RX and TX between the devices connect the 5volt pin on the TTL USB to the 5vt pin on the wt324 on your computer next connect the io0 PIN to the ground on the project board you should then see the red LED light up and the green LED on the [Music] wt324 2 device is now ready to receive the code [Music] upload after the upload process to run the program that has been uploaded disconnect the io zero pin from the ground then connect the ground pin on the WT 32b let's proceed with the wiring of the device as explained earlier First Connect RX to TX and TX to RX make sure to make cross connection between RX and [Music] TX next connect the 5volt pin from the TTL USB to the 5volt pin on the [Music] wt324 TTL into a USB port on [Music] [Music] computer next connect the io0 PIN to the ground on the project board you should see the red LED and the green LED are turning on [Music] afterward connect thean pin to the ground and you will notice the green LED turning off disconnect the pin from the ground and we are ready to upload code from Arduino IDE to [Music] wt324 LED on and off we will use the blink code [Music] [Music] example since the [Music] wt324 [Music] then I add a Serial print statement to monitor the LED status through the serial [Music] monitor [Music] [Applause] [Music] before uploading the code configure the device by selecting the device to be used which is the ESP Dev module and choose the port number connected to the TTL [Music] USB [Music] next click upload button to start upload code to [Music] wt324 ground then connect the ground pin on the [Music] wt324 connect the negative lead of the led to the ground and then connect pin number two to the positive lead of the LED as the [Music] output the program we've uploaded will run and the LED will turn on and off alternately with 1 second [Music] delay in the serial monitor you can observe the serial prints that have been included in the [Music] code thank you for watching I hope this video will be helpful don't forget to like And subscribe see you in the next video

Channel: Yaser Ali Husen

Views: 10,795

Keywords:

Id: W6hmV76SRHs

Length: 7min 46sec (466 seconds)

Published: Sun Nov 05 2023