Plastic Welding: How To Instructional Video by Techspan

Tech span has supplied high quality plastic welding process heating systems for over 30 years tic span innovative design and precision engineering for trouble-free plastic welder this video outlines the basic steps of the hot air thermoplastic bowling process almost all thermoplastics can be welded and provided you follow a few fundamental steps professional strong worlds can be achieved as of all forms of welding good surface preparation will ensure successful welds and very paper a sharp blade or a clean wire brush can be used the Tex pan plastic welder is fully self-contained incorporating a built-in bar and electronic temperature control all the necessary attachments can be supplied in kit form or purchased individually use the rotary burr to cut a theme for repair well then drill a small hole at the end of the crack take care when using the rotary verb use adequate jigging and support the accessory nozzles are an easy push foot on the welding tool carefully select the correct welding temperature using the guide provided prior to the main welding attacking nozzle is fitted to the welding tool once up to temperature the tacking nozzle is run along the entire length of the area to be welded tacking should be carried out wherever you intend to place welding rod tacking provides a slight swaging for two materials and once complete you are then ready for the main welding there's only like materials can be welded correct welding rod selection recycled plastics identification can be carried out using the check span drop test kit set the correct world and temperature on the welding tool but correct mating between the world in rod and the parent material occurs when the world in waters seemed to suffer a new rod is fed into the world area welding should be complete in one continuous run along the length of the area to be welded the pendulum welding technique is used for short world's repairs or when excess is difficult the standard pendulum Weldon nozzle is fitted and a pendulum action provides correct even heating to both the welding rod and the parent material the speed welding nozzle can be used for long world runs worldin rod is fed into the speed welding nozzle with the operator applying approximately two to three kilos of downward pressure sufficient to force the now softening world in rod into the world area please ensure you read two operating instructions before use tics pants apply a full-range plastic welding equipment a thermoplastic well it rocks expand also offer service of backup of all major brands you

Channel: TECHSPANONLINE

Views: 2,558,745

Keywords: Plastic-welding, Plastic-welding-tools, Techspan, Bak, Dohle, Herz, Leister, Rion, Plastic-welding-rods, Hot-Air-Tools

Id: HvV9a3lEe2g

Length: 4min 51sec (291 seconds)

Published: Mon Sep 27 2010