Juno SlimForm™ 11", 12, 13" & 14" LED Surface Mount Installation

this video demonstrates the installation process for 11 inch 12 inch 13 inch and 14 inch Juno slim form led surface mount down lights first remove all fixture components and the parts pack check that all parts are included before wiring the fixture to the power supply turn the electricity off at the fuse or circuit box secure the mounting bracket to a flush mounted junction box using the number eight screws provided attach one side of the mounting bracket make sure the straight side of the mounting bracket is parallel to the nearest wall the mounting bracket needs to be oriented properly to the ceiling markings on the bracket state which side to face into the room do not fully tighten this screw some space will be needed to complete the next step with the second number 8 screw attach the eyelet of the tether cable between the junction box and mounting bracket making sure the tether cable is coming out from the center of the mounting bracket tighten both screws attach the s hook on the tether cable through the hole in the fixture clip with the power turned off use a wire nut to connect the green ground wire from the fixture to the ground wire from the junction box twist clockwise until tight if the existing wiring does not include a ground wire consult your local electrical code for approved grounding methods use wire nuts to connect the black fixture wire to the black power supply wire and the white fixture wire to the white power supply wire for fixtures with 0 to 10 volt dimming use wire nuts to connect the violet dimmer wire from the fixture to the positive wire from the dimmer and the gray dimmer wire from the fixture to the negative wire from the dimmer see the dimmer electrical schematic for more information use the provided stickers to mark the ceiling near the indent openings place a sticker on the side of the fixture in alignment with the mounting tab position the wires up and into the outlet box lift the fixture up to the ceiling with tape marks aligned and rotate the fixture 90 degrees clockwise until the fixture locks in place once secured remove the stickers from the fixture and ceiling turn the electricity on at the fuse or circuit breaker box and verify the fixture functions properly installation of your Juneau slim form down light is now complete you

Channel: Acuity Brands Inc.

Views: 316,939

Rating: 4.6391206 out of 5

Keywords: Juno, surface mount, LED downlights, installation, SlimForm, slim form, round downlight, square downlight, JSF, JSFSQ

Id: mpDOAcTo80o

Length: 2min 55sec (175 seconds)

Published: Thu Dec 14 2017