I was using a chipless printer and replaced it with a new head. But it doesn't work properly when I plug in a new head.
It needs to be sorted right away, but it doesn't work. It is recognized, but it only appears that it is still sorting.
(Sometimes it is not recognized) So today, I'm going to show you how to set up a new head on a non-chip device
(There is also a way to recognize a new head on a device with a chip!) Let me set it up
Please turn it off and on again There's no response even if I put in a new head Press BACK 4 - Enter the Support Menu System Configration Menu -> OK TRADE at OOBE -> 'OK' Trade supplies ‘Disable’ ... Press "OK" in order for "Disable" to become "Enabled"
Press the 'X' button to exit. In the Trade at OOBE menu, press the arrow key twice to change to Inkitalization status and press the OK button. Initialization status: Set... -> Press 'OK' to make 'Set' clear In a clear state, open and close the front cover to see if it's pumped
(If you pump it, the setting is done.) There's no response right now I'll get out of it and try it. I'll open and close the front cover and see if it's pumping Yes, this is pumping
It's all set Please wait until the pumping is over The machine pumped it, so I'll sort it out. Settings - Printer Maintenance - Printer Head Alignment - Continue It's a misalignment I'll try turning it off and on again. After pumping, turn it off and on again Let's sort it out. It's aligned now When the alignment paper comes out and the success message pops up... I succeeded. Settings - Reports - Printer Status Report
I'll print it out Yes, like this, the status report comes out well. This is how to reset the new head and use it. I'll teach you how to set up the baby's device in the beginning 1. Close the printer cover after installing the infinite cartridge as shown in the picture. 2. When the following message appears, open the printer cover. 3. Close the cover when you receive the open cover message. 4. When the message "Use SETUP cartridge" appears, press the BACK button 4 to 10 times. 5. Enter the Support Menu. 6. On the Support screen, press the right arrow. 7. On the Sistem Configuration Menu screen, press the OK button. 8. On the Trade at OOBE screen, press the OK button. 9. On the Trade screen, press the OK button to change to Enabled as shown on the screen. 10. I opened the cover of the printer cover Close it. 11. When the following message appears, press the OK button. 12. Press the Continue button on the next screen and use it when the printer LCD screen appears as the main screen. The end!
