How to Hide Your TV Wires | EASY

Video Statistics and Information

Video
Captions Word Cloud
Reddit Comments
Captions
hey guys welcome back for this weekend project i'm going to show you how to get rid of the cords by your tv just like that so stick around and i'll show you how to do it [Music] the only tools you'll need for this project are a drywall knife fish tape tape measure some rope and also stud finder and as for materials all we need are two of these low voltage recessed cable plates from commercial electric so these slide into the holes after you cut them and have these tabs that when you tighten it they latch onto the wall so to get started on this project we need to pull the tv console out pull the sound bar off the wall and the tv off the wall and then pull the cables [Music] once you have everything clear you can go ahead and mark out your locations of your studs then you can use the template that's included with the wall plates and mark out where you need to cut the reason we need to find the studs is so that we can avoid them another thing that's really important is to ensure that these boxes are vertically in line this will be very important later when we're fishing the wires through [Music] once you finish marking you can move on to cutting out the boxes i recommend using a drywall knife some people use utility knifes it just depends on your situation it is much easier in my opinion though to just pay the four dollars in harbor freight and get a cheap drywall and as you can see here a good trick is to drive a screw in there that way it doesn't fall behind the wall and it's super easy to fish out of there then we just need to install these plates and we're good to fish the wires through [Music] now this fish tape is what i'll be using to fish the wires up to the wall this process is a little bit of a guessing game but even if you have a wall with insulation like i do here you'll still be able to fish it through in a few minutes [Music] in my experience it's easiest to tie the cord about six to eight inches below the tops this means it'll be easier to fish it through the cable [Music] plate now since i had my sound bar mounted to the wall getting the cables there was a bit of a challenge but i was able to solve this by cutting a one inch square hole i could then run the cables necessary for the sound bar through that little hole and maintain the cordless look they don't make cable plates small enough for holes like this but it's not going to be the end of the world because it will be completely concealed behind the sound bar as you'll see later something worth mentioning is that you should only be running data cables or optical fiber cables through these walls and running a standard power cable through the wall is dangerous because they've been known to heat up quite a bit during use [Music] so [Music] and after getting everything back in place we could call this project done [Music] this project was super easy and it's a really good way to clean up all of those ugly wires and the fact that i did it for 25 bucks including the fish tape and the drywall knife is awesome so that's it for this one if you enjoyed the video please like and subscribe and i'll catch in the next one [Music]
Info
Channel: The Weekend Builder
Views: 2,151,074
Rating: undefined out of 5
Keywords: how to hide tv cables, how to hide tv wires, hide tv cables, hide tv wires, how to get rid of tv wires, how to wire tv cables behind wall, how to run wires through insulated wall, tv console, tv console upgrade
Id: zt8dh5wudMQ
Channel Id: undefined
Length: 4min 38sec (278 seconds)
Published: Thu Sep 30 2021
Related Videos
Note
Please note that this website is currently a work in progress! Lots of interesting data and statistics to come.