How to connect 2 Internet links to Fortigate Firewall

Hello friend welcome to my video In this short video, I show you how to connect two wan with fortigate firewall Connect the FortiGate to your ISP devices by connecting the Internet-facing ports on the FortiGate to your ISP devices. Connect WAN1 to the ISP that you want to use for most traffic, and connect WAN2 to the other ISP if this step is not configured, there are only 2 modes on the interface: Static and DHCP First create pppoe dial-up profiles for the WAN ports on the Fortigate device Go to Network -> Select Interface -> Select the interface you want as an WAN port to dial the PPPoE PPPoE In Role: Choose WAN In address In Address: Choose PPPoE In Username and Password: Enter username and password provided by your carrier In Username and Password: Enter username and password provided by your carrier You do the same on 2 WAN ports Create the sd-wan interface Under SD-WAN Interface Members, select wan 1 Set the Gateway to Dynamic Repeat these steps to add wan 2 Go to Network > Interfaces and verify that the virtual interface for SD-WAN appears in the interface list Go to Network > Interfaces and verify that the virtual interface for SD-WAN appears in the interface list Go to Network > SD-WAN Rules In the Load Balancing Algorithm field, select Volume, and prioritize WAN1 to serve more traffic. the example, the ISP connected to WAN1 is a 800Mb link, and the ISP connected to WAN2 is a 200Mb link, so we balance the weight 80% to 20% in favor of WAN1 so we balance the weight 80% to 20% in favor of WAN1s Create a static route for the SD Wan interface Go to Network > Static Routes and create a new route Go to Network > Static Routes and create a new route In the interface field select the sd-wan interface from the drop-down list Ensure that Status is set to Enable Configure a security policy that allows traffic from your organization’s internal network to the SD-WAN interface Set Incoming Interface to the interface that connects to your organization’s internal network and set Outgoing Interface to the SD-WAN interface Set Source, Destination Address, Schedule, and Services is all Make sure the Action is set to ACCEPT Turn on NAT Enable Log Allowed Traffic for All Sessions to allow you to verify the results later You can now browse the Internet using any computer that connects to the FortiGate's internal interface You can configure link health monitoring to verify the health and status of the links that make up the SD-WAN link Go to Network > Performance SLA and create a new performance SLA In the Server fields, enter the IP addresses of up to two servers that you want to use to test the health of each SD-WAN member interface. In the Server fields, enter the IP addresses of up to two servers that you want to use to test the health of each SD-WAN member interface. In the Participants field, select the SD-WAN interface members that you want the health check to apply to As always if you found this post useful then subscribe to my YouTube channel Help me 500K subscribers

Channel: NETVN

Views: 11,204

Keywords: netvn, net vn, fortigate dual, fortigate dual wan configuration, fortigate dual wan failover, fortigate dual wan, fortigate 2 wan interfaces, fortigate 2 wan load balancing, fortigate 2 internet connections links, fortigate firewall configuration step by step, fortigate firewall, fortigate firewall tutorial, fortigate 2 internet links, fortinet firewall tutorial, fortinet firewall, fortinet load balancing configuration, fortinet sd wan configuration, fortigate sd wan setup

Id: YUqSv2BmOwo

Length: 4min 54sec (294 seconds)

Published: Tue Sep 07 2021