Easy and safe way to break a tire bead

hi youtubers today I want to show you how to quickly unseat the beat from a large tire I've seen a bunch of different people doing this on the internet I found that probably the most efficient and fastest way to do it is to use a beat breaker hammer but since I'm only doing the few tires on my own I don't feel like investing that much money into it because it would cost $80 for a tool that was rarely used so what I'm going to do is show you how to do this with just simple tools that you probably already have laying around your garage so here's what we're going to need we have our standard floor jack just a regular thing that you're using to attack up your car all the time when you're working on it and we also have a ratchet tie-down strap and then of course this is our valve core removal tool so first let's start with removing the valve core so we can get all the air out of the tire here's my strategy I'm going to use the lifting saddle the jack to push up against the side wall the time what I want to do is push right against the edge right here but not get it on to any part of your aluminum wheel so the tricky thing is to get this thing positioned right and also have it held down against the jack so it doesn't move very much while I'm doing this that's where the tie-down straps will come in handy so first I'm going to lift up the saddle just a little bit so I can get a better idea about where I'm positioning this I'm going to put my tie-down straps onto the axle of the jack and I'm going to lift the tire on here okay let's take a look underneath here before me you see where the where the saddles position you want the saddle to be on the rubber not on your aluminum wheel right here I'm doing this kind of I feel here's the saddle of the jack right here and here's the rubber part and just enough rubber between there and the aluminum wheels so that way my saddle can push up but it's not going to be pushing on the wheel now I'm going to thread just tie-down straps II this lots of my wheel and this part of the tie-down strap is going to go under the jack she's gonna go under the jack frame right there and run it through my ratchet and I'm gonna tighten this up a bit I'm going to go ahead and knock the jack back down we want to check over here just by feeling make sure the tires on the saddle if you leaving the wheel is not go and we'll just jack it up even here the tire squeaking and rolling with you're jacking it up get it off the beat here and after it squeaks and groans enough you look under here and there we go we've got it off the bead now that did come off pretty easy you have to admit that I just changed this tire about two weeks ago so it wasn't glued on really really tightly like the previous one was but this is the same technique that I used two weeks ago to get it off so hope this saves you a lot of time in trouble and let me know what you think

Channel: auxpowerunit

Views: 2,628,217

Rating: 4.7198782 out of 5

Keywords: tire, tire bead, how to change tire, DIY tire, bead breaker, bead breaking, bead unseating, manual tire, tire demount, tire removal, tire unmounting, tire dismounting, tire bead breaker, tyre dismounting, tire changing, car tire, truck tire, Hummer, H2, remove tire, car, vehicle, car repair, aluminum wheel, Goodrich KO

Id: 0uyuZhj3fnw

Length: 5min 19sec (319 seconds)

Published: Sun Oct 09 2016