Cutting hard foam outside and inside

okay this is the sterile cutter the thread is a perfect 90-degree angle I had my foot pedal on and off so put it on the floor okay and first of all I put is design I have my art foam block and first let's draw a little chapel did a few lines but let's say freehand something like this well I record this outside so you'll hear all kinds of knowledge that shouldn't be here but anyway so here is the simple I would like to cut out of one piece of foam and let's see with the proximities guide I will not use this one because it's a it's not so stable so I will use my own guide ER and let's start with the outside okay now the heat not too hot but okay now we go Scott as I said let's start with the outside Thanks well not much hotel here just take care of the wire is not too hot and take your time now this is a tricky one because the part is not straight so first you'll have to fix that and there I go ok that's ok in the end I'm going to have a straight cut somewhere near the black line that's good enough as you see it's all down a very good place I think to any measuring so it's just cutting by the eye and later on I can adjust the walls if I want to let me see [Music] okay now we have to do some cups right here and here we have to go in and make a bent first of all Dwyer is intention and now I have first I want to check the heat so I want to check it to see how quickly oops how how does it behave now you see the wire is very hot so I have to move very quickly so I will adjust go down a bit just to get the right temperature and the right speed if I push too hard the wire will be pushed away which isn't good because then I get a cut that isn't totally straight for genetics and so let's try it and so the power is off I turn it okay [Music] everything goes according to plan so it's a little careful with a tower and it might be the entrance well what us to go this is a pretty one nice very nice and there we go well I think we have the outside now so this is the outside of the church and now I have to go inside it means I will go inside the block and I will start cutting all the way around and even if I do that well then I can get the inside out in one piece and now it's very important that the wire strike so wire is still a bit too hot Warren and I would like to live in that say one centimeter there we go so I will move up to one centimeter that's it now I rotated make sure your wire is that I can you agree angle you can test it by quickly turning on and off the power and it is okay there we go easy does it so this is a very very very unprofessional video but hey I only want to show you how to cut a church in about five minutes or at least that's the base of it you see I mustn't push too hard because otherwise I will get a foolish trade cut not so far well steady hand does help almost there okay so let's see now I remove the wall a bit and move the deciders there we go yes so let's see what is whatever and if I'm mistaken then there is my church and as you can see apart from the point where I got in all the angles are smooth there are no joints and the inside is fairly nice as well so here you have your basic structure for a chapel okay this wraps up my first very unprofessional video but I hope this helps thank you bye

Channel: Shiftinglands

Views: 64,680

Keywords: Hard foam, Styrodur, cutting, scenery

Id: 7WCh6d4U6QE

Length: 13min 5sec (785 seconds)

Published: Wed Jun 21 2017