Chambering A Barrel

set up here to chamber chamber girl this barrel has been chucked in a dead troop Chuck the center tailstock centre has been run in the breech end of the barrel this steady rest is adjusted around the barrel so that when you turn the lathe on the girl is running true notice that this barrel is running true and Dan where things already true it's been set up on centers pull the tail stock back here from the barrel got a chamber green this is the 300 Weatherby dream agreement that's held by a lathe dog this is called a lathe dog the dog is taken under where the chamber dreamer all chamber dreamers are made with a center there they're machined and ground on centers each other the reamer has us as a descendant to take the chamber reamer dip it in the oil Center rarely came slide it into the slide in with the girl slowly buckle up I've nearly finished this chamber already I need to just deepen this chamber just a couple of thousands tailstock I'm mighty late here just graduated two and a half thousand graduations this instance I need to deepen that chamber by that amount here we got the chamber cut to the depth of we need it to now I'm going to pull the chamber dreamer out of the barrel ladies the lathe just stopped set my dreamer side turn it back on like the rear of the Jean Brown [Music] griever chips rear of the chamber this is a Magnum headspace gauge insert that into the reach-in of the barrel this is the depth micrometer thousands of an inch these are my depth here tells me that I actually need to go just a little bit deeper from the laid-back on agreement that gets Berle [Music] took another when thousands and a half by the chamber reaching chamber out chips in there take my headspace gage but in the breach the rural again the depth micrometer held on the reach of the barrel measures down on the headspace gauge I'd leave them work the required depth change that you're gonna leave so my label run run fast I've got 400 grit paper here that I use we're wrapping around [Music] this little tool here turn my lathe on change my vapor from 400 to 600 grit nice polish the chamber I need my barrel believe take it over the other side of the shop putting the barrel vice and tighten the action on it and check to see the proper headsman [Music] you [Music] you

Channel: undefined

Views: 63,693

Rating: 4.8940091 out of 5

Keywords: the real gunsmith, randy selby, gunsmith, gunsmithing, rifle barrel, chamber a barrel, chambering a barrel, rifle chamber, hunting rifle, long range rifle, long range hunting, rifle manufacturer, custom rifle, rifle build, lathe, rifle making, rifle maker, gunsmith technique, rifle construction, firearm build, custom firearm, firearm

Id: I0_nYPT2wws

Length: 6min 5sec (365 seconds)

Published: Mon Oct 02 2017