Arduino Nano Project! | Relay Control By Push-Button Using Arduino Nano!

[Music] hello guys welcome back from the video from the innovators as the pandemic situation is trending all around the world we are here to make your quarantine as productive as possible in this video we'll be looking at how to conclude a relay using a push button before starting the video guys if you haven't subscribe our channel yet so do it to watch our latest uploads as soon as possible let's jump into the video for this circuit we need one relay module one Arduino Nano one push button one LED one resistor some jumper wires and a bulb with extension wire for the input relay module we have three pins in which one is the ground one is the VCC and one is for the input signals connect any part of the push-button the d2 pin of arduino nano the second pin of the push button needs to be connected with the ground pin of arduino nano furthermore the ground tone of the relay needs to be connected with the ground pin of arduino nano [Music] for the time being leave the signal fin of the relay connected draw on the breadboard and connect the VCC pin of the relay with the 5 volts pin of arduino nano now we will take the LED and connect its positive with the signals when of the relay module after that connect the negative of the LED with the 1k resistor placed on the breadboard and the remaining leg of the resistor needs to be connected with the ground of the arduino nano [Music] last but not the least connect the signal pin of the relay module with detent pin of arduino nano [Music] [Music] [Music] now let's look at the coding part this is our Arduino code first of all click on the tools after that click on open and select the board as our Dino nano moreover said the poor adoption com3 on which we connect the cable to our Arduino Nano later on the top-left corner you need to select the option compile and run to burn the code on arduino nano board after you are done with the coding connect the source to our Arduino Nano world we can see that our relay is on and when we press the push button on a level switch off which means that the relay served as the switch and when we connect the source our relay works as the closed circuit and when we press the push button again our relay serves as the open circuit for output we need to break the phase wire and one is connected with an O for normally open another is connected with common [Music] you [Music] nc or the normally-closed is not used because it's always closed after it is connected to the bulb and on the 220 volts we can see or observe the output [Music] [Music] [Music] [Music] so guys that's it for today I hope you guys liked the video if you did please hit the thumbs up and also subscribe our channel to watch our latest uploads as soon as possible also join us on Facebook and Twitter the links are in the description below guys we need your encouragement for our motivation see you guys in the next video peace out

Channel: E-Innovators.

Views: 15,248

Keywords: arduino tutorial for beginners in english, arduino, arduino step by step your complete guide, relay, push button, arduino projects, relay control bu push button using arduino, relay control, arduino nano, controling led relay, bulb, control led using push button, arduino ide, programming arduino project, arduino programming, led, arduino nano project, breadboard project, resistors, jumperwires, led blinking, control led by a push button, E-innovators

Id: qPKNviHTVVs

Length: 5min 59sec (359 seconds)

Published: Wed Apr 22 2020